Cam Follower and Track Roller - Stud Type

Contact Now

Stud-type track rollers, such as cam followers, have a built-in threaded rod, instead of an inner ring, for either threaded mounting or through-hole mounting onto machine components. Through-hole mounting uses a hexagonal nut on the threaded end to secure the bearing into place. Yoke-type track rollers, such as roller followers.Stud type track roller bearings CFS3V IKO cam follower bearings is roller bearings with cylindrical rollers that are small in diameter. In spite of their low cross section, needle roller bearings have a high load carrying capacity and are therefore extremely.

 

 

Cam Followers (Stud Type Track Rollers) Without seal With seal 1. Types Cam followers are available in the standard types shown in Table 1. These standard bearings have a screwdriver slot built into the stud head, while the outer rings have a cylindrical outside surface. Cam followers, which are equipped with a thick outer ring.

 

 

 

 

SMITH CR-1-B-SS Cam Follower and Track Roller - Stud Type

6.65 kN 5.5 Nm
49 mm PG204N-

SMITH CR-3/4-B-SS Cam Follower and Track Roller - Stud Type

Deep Groove Ball Bea Single
Yes (with retaining 56

SMITH CR-5/8-B-SS Cam Follower and Track Roller - Stud Type

0.37 Hz 4.43 Hz
8 mm 24 mm

SMITH CR-1/2-B-SS Cam Follower and Track Roller - Stud Type

No Bearing Steel
No Medium Load

SMITH CR-2-SS Cam Follower and Track Roller - Stud Type

12 DB
42 No

SMITH CR-1-5/8-SS Cam Follower and Track Roller - Stud Type

20 mm M8
5.5 Nm 9.55 kN

SMITH CR-1-1/2-SS Cam Follower and Track Roller - Stud Type

With Outer Ring Ball
VV Standard

SMITH CR-7/8-SS Cam Follower and Track Roller - Stud Type

0.945 Inch | 24 Mill NTN
Open 3,200 rpm

SMITH CR-1-3/4-SS Cam Follower and Track Roller - Stud Type

115.9 mm 90 mm
160 mm 120 Nm

SMITH CR-1-1/8-SS Cam Follower and Track Roller - Stud Type

Double 7 Days
Yes (with retaining [Aluminum Alloy] 201

SMITH CR-1-3/8-SS Cam Follower and Track Roller - Stud Type

NTN 124 mm
28 mm 120 °C
1/10